3270 Ver406-06)
13
Shares: Lists the pools shares, which are grouped by pool.
Legacy Disk Shares: Lists foreign shares (if any exist).
The CIFS and NFS protocols are read-only, unless write permission is granted. Similarly,
the FTP and HTTP protocols are read-only, unless create and/or delete permission is
granted. The create permission allows users to create new files but not alter existing files.
The delete permission allows users to modify and delete existing files. If a share has
delete permission but not create permission, users can modify or delete files, but cannot
add them.
To rename an existing share, click Rename Share.
To create a new share, click Create New Share.
CREATE SHARE
The Create New Share page allows you to create a new share in an existing pool.
In Workgroup Member mode with PBSA, the Enable Share Authentication security
feature should be enabled. When enabled, this feature provides share-level security
through password protection of Windows shares. In Workgroup Member mode with
UBSA, users are listed under share permissions. This feature provides control access to
the newly-created share on a user-by-user basis. If more-advanced security features are
required, configure the DiskGO as a domain controller (See “Primary Domain
Controller).
To create a new share in Workgroup Member mode with PBSA
1. Type the name of the new share in the New Share Name box.
2. In the Create in Pool list, click the pool where the new share is to be
located.
3. Select the Enable Share Authentication check box to password protect
the share. Otherwise, the share can be accessed by anyone that is able to
connect to the device.
4. Type the password in the Share Password box and again in the Confirm
Password box.
5. Click Create Share.
To create a new share in Workgroup Member mode with UBSA
1. Type the name of the new share in the New Share Name box.
2. In the Create in Pool list, click the pool where the new share is to be
located.
3. Opposite Shares Permissions, click the permission type to be granted to
each user.
4. Click Create Share.
SHARE ACCESS
The Share Access page allows an administrator to view and modify share access. This
page is available only if the DiskGO has been configured as a member of a workgroup. It
To Next Page
Loading...