3270 Ver406-06)
19
4. Select the number of mirrors from the Number of Additional Mirrors
field. Note: the number of mirrors must be equal to the number of
additional physical disks connected to the DiskGO drive.
5. Within Disk Assignment select the appropriate checkbox for the drive
where the mirror will be stored. Select Add Mirrors.
REMOVE MIRRORS
On the Remove Mirrors/Spares page, you can remove mirrors/spares from existing pools.
If one of the disks of a mirrored pool has failed, you must use this page to remove the
mirror from the pool.
1. Open the Remove Mirrors page from the Disk Management menu
2. Select the pool you wish to change from the Pool Name field
3. Select the mirror device from the Available Mirrors list and select
Remove Mirrors.
POWER MANAGEMENT
On the Disk Power Management page, you can modify the spin down times of the
available disks when they are idle. The times specified can be given in 5-second intervals
up to a maximum of 5 hours 30 minutes.
NETWORKING
LAN
The default IP addressing for the DiskGO 3.5” Network Hard Drive is as a DHCP client.
Most networks and gateways use DHCP protocols to assign IP address to connected
devices. The DHCP client setting will allow the network to automatically assign an IP
address to the DiskGO. If you wish to change this setting to DHCP Server or Static IP
follow the steps below.
DHCP Server
This setting will change the DiskGO from a client accepting an IP address from the
network to a providing IP addresses to other devices (computers, servers, printers, etc.)
connected to the Network. By changing this setting it may make it necessary to change
some network and other DHCP settings manually. To change the DiskGO to a DHCP
Server follow the steps below.
1. Select LAN from the Networking menu
2. Select DHCP Server from the LAN Protocol dropdown list.
3. Within LAN IP Address enter a static IP address for the DiskGO. Make
certain that the IP address selected is on the same LAN segment as the
computer running Administrator.
4. Set the IP address as necessary to function on your network:
o LAN Domain Name
o LAN DNS Servers (preferred and 2 alternates)
o LAN WINS Servers (preferred and 2 alternates)
5. Click Apply and Continue
To Next Page
Loading...