Edge DiskGO - Firmware

3270 Ver406-06)
6
On the Administration - Basic page, you can view and modify the following basic
DiskGO administration settings:
• DiskGO machine
• Administration user name (preset to edgetech)
• Administration password (preset to admin)
• DiskGO Time
• Browser Time
• Time Zone Region
• Time Zone Country
• Time Zone City
• NTP servers
The DiskGO software keeps track of the date and time and uses this information to
timestamp files and for administrative purposes such as error and connection logging.
The DiskGO clock runs in real time and has a battery to keep the clock running even
when the power to the DiskGO is turned off.
The current date and time as recorded by both the DiskGO and the PC connected to the
device is displayed. To manually set the DiskGO time, click Set Time Manually. To set
the DiskGO time to match the PC connected to the DiskGO Share, click Set DiskGO
Time to Match.
The DiskGO 3.5” Network Hard Drive is also capable of synchronizing the date and time
settings on the network. DiskGO drives which are on networks connected to the Internet
should usually be set up to do this. This kind of network time synchronization is done
through an international standard called Network Time Protocol (NTP). There is space
opposite NTP Servers to type the IP addresses of three machines for the DiskGO to use
in determining the current date and time. The default IP addresses are 192.5.41.40,
192.5.41.41, and 133.100.9.2. The first two of these IP addresses is a server run by the
United States Naval Observatory as a public service to provide the precise time over the
Internet, and the third is a similar time server in Japan.
Use the spaces opposite the Time Zone Region, Time Zone Country, and Time Zone
City to make local time zone settings.
To perform a software reboot of the DiskGO, click Reboot.
To restore the DiskGO to the factory settings, click Restore Defaults (this option does
not delete any digital files saved on the DiskGO).
FIRMWARE
On the Firmware Administration page, you can view the current DiskGO firmware
version and upgrade the firmware to a newer version, if available. Always note the
version information when contacting technical support.