3270 Ver406-06)
18
1. Select Basic from the Disk Management menu.
2. Within Disk Pool Mapping select Change Encryption
3. Select the pool you wish to change from the Encrypted Pool Name list.
4. Select Enable Pool Encryption from Encrypt Pool
5. Enter the new password within the New Password and Confirm
Password fields. Note that only alphanumeric characters may be used.
The password also should be at least 8 characters long. Select Change
Encryption
Disabling Pool Encryption
1. Select Basic from the Disk Management menu.
2. Within Disk Pool Mapping select Change Encryption
3. Select the pool you wish to change from the Encrypted Pool Name list.
4. Select Enable Pool Encryption from Encrypt Pool
5. Leave both New Password and Confirm Password blank. Select
Change Encryption.
Remounting Encrypted Shares
Encrypted pools must be mounted each time the DiskGO 3.5” Network Hard Drive is
rebooted, powered off, restored, or removed from the network. Follow the steps below to
remount an encrypted pool.
1. Select Basic from the Disk Management menu.
2. Click on the Enter Encryption Password button from the Disk Pool
Mappings section for each encrypted drive you want to mount.
3. Enter the passwords for each pool within Encrypted Pool Names and
select Mount Pools.
RESIZING POOL*
1. Open the Resize Disk Pool page from the Disk Management menu.
2. Click the name of the disk pool that you wish to change in the Pool Name
list.
3. In the Space Allocation boxes, type the amount of allocation space
(gigabytes), or use the slider to specify the allocation space for each pool.
4. Click Resize Pool.
*Pools cannot be reduced in capacity to a size less than the space consumed by the shares
within the pool.
ADD MIRRORS
If additional disks are available, you can add mirrors to existing pools. Also, you can
convert a JBOD (just a bunch of disks) pool to the mirror pool. To add mirrors/spares,
follow the steps below.
1. Open the Add Mirrors page from the Disk Management menu
2. Select the pool you wish to mirror from the Pool Name field
3. Select the mirror device from the Mirroring field
To Next Page
Loading...