Edge EDS500.2FD-E0 - Power Cable; Ground Cable; RCA Cables

5
Power Cable
Ground Cable
RCA Cables
• At least 4 gauge cable should be used for the ground connection to the amplier.
• The amplier ground should be connected directly to the chassis of the vehicle, to
bare metal.
• The cable length should be kept to an absolute minimum.
• It is not recommended that you connect the ground cable to the vehicles seatbelts
anchor point.
• At least 4 gauge cable should be used for the power connection to the amplier.
• The power cable should be taken directly from the battery. Rubber grommets should be
used when passing through any bulkheads to prevent the cable from becoming chaffed
or cut.
• It is vital that a fuse / circuit breaker (of at least equal value to the one tted in the
amplier) is placed inline with the power cable and is no further than 18 inches away
from the battery.
• Please ensure that the fuse is not tted until the entire installation procedure is complete.
• Depending on the model number of your amplier and the number of speakers you
wish to power you will have to run either one or two or RCA cables from the source to
the amplier.
• Please take extra care when running these cables from the source to the amplier.
Ensure that they are placed away from all items that can generate any interference,
wiring harnesses etc.
• It is recommended that the RCA cables should be run on opposite sides of the car
to the previously installed power cables if possible, to avoid the cable picking up
interference.