If you would like to view Parameter IDs (PIDs) specic to your vehicle, following these
instructions to learn how to view them using your HT2 device.
CAUTION: Do not exceed legal speed limits on public roadways.
VIEWING GAUGES
STEP 1 - Enter the
Scan Menu.
STEP 2 - Select
Gauges/Datalog.
STEP 3 - If asked,
turn ignition on,
but do not start.
STEP 4 - Follow
the on-screen
instructions.
STEP 5 - Select a PID Group, then select
a total of 4 PIDs. Use the
/ arrows to
switch between screens. OK to select.
While viewing gauges,
press OK to start
Datalogging
Press OK again to stop
Datalogging
Press OK to continue
STEP 6 - Follow the on-screen
instructions. Note the RED highlights.
See DataLogging for more information.
Select 4 PIDs within the
following menu
Press OK to continue...
PID Groups 1/1
Engine Misc
Fuel Trim/Press
Time/Distance
Oxygen Sensors
Misc Non-Engine
Egr/Evap
Catalyst Temp
Throttle Detail
Engine Misc 1/1
Calc Eng Load
Engine Coolant Temp
Manifold Abs Pressure
Engine RPM
Spark Advance
Intake Air Temperature
Mass Air Flow
Abs Throttle Position
GAUGES / DATALOG
To Next Page
Loading...
Need help?
General