My HT2 does not power up when plugged into the
OBDII port?
PYour vehicle’s OBDII port is powered through a fuse the
fuse may be blown. (In most vehicles, this is the same fuse
shared by the cigarette lighter)
PTry the HT2 on another vehicle to make sure it powers
up. If it does, then the wiring on the vehicle you are
trying to program may be the issue.
----------------------------------------------------------------------------
My HT2 Says: “Non-Stock File Detected...”
PYour vehicle may have been programmed by another
device. Use that device to set your vehicle back to stock
before using the HT2.
----------------------------------------------------------------------------
When reading the vehicle’s trouble codes (DTCs), I received
a P1000 error code?
PP1000 is a DTC that sometimes appears after a vehicle is
programmed or the battery cables are unplugged from the
battery. It will automatically clear after several drive cycles.
It cannot be removed using the ‘DTC Clear’ function.
TROUBLE SHOOTING
To Next Page
Loading...
Need help?
General