9
Operating this unit
The LCD Display will show the ambient temperature by default.
Pressing the Up and Down buttons on the remote control will show
the set temperature for 15 seconds, and then revert to the room
temperature. You can switch between Fahrenheit and Celsius by
pressing the C/F button on the remote control. Please revert to the
“Indication Symbols on LCD” for full list of mode/fan/temperature
indications.
The unit will remember the last used mode/settings if you shut
down and restart.
Auto-Restart: If power to the unit is interrupted, the air conditioner
will restart itself in its last used mode/settings once power is
restored. The compressor will restart after 3 minutes.
In this mode, on the fan of the air conditioner runs and circulates
the air in the room. To activate this function mode, press the
MODE button on remote or control panel until fan only symbol
appears on the displays. There are three fan speeds:
High Fan Speed
Medium Fan Speed
Low Fan Speed
Cooling mode cools and dehumidifies the air. If the ambient
temperature drops below the temperature you selected, the
compressor turns off and the unit functions with the fan only. When
the temperature rises above the temperature you selected, the
compressor turns on again.
Installing the batteries
LCD Display
Power Button
Fan Mode Only
Cooling Mode
CAUTION: Use only AAA batteries. Remove the batteries if the remote control will not be used for
one month or longer. Do not attempt to recharge batteries not designed to be recharged. All
batteries should be replaced at the same time. Do not mix old and new batteries. Do not dispose of
batteries in a fire as they may explode.
AAA
AAA
AAA
AAA
1) Remove the cover on the back of the remote control.
2) Insert the batteries with the (+) and (-) ends pointing in the
correct direction.
3) Install the cover on the remote.
NOTE: Fan Only mode does
not require that the exhaust
hose be attached.
To Next Page
Loading...
Need help?
General
