10
EdgeStar’s Draft Beer Dispenser comes with a single gauge CO
2
gas regulator that has
a 0-60 lb. pressure gauge showing the gas output pressure.
Once the regulator is securely attached to the gas cylinder:
1. Close the shut-off valve on the regulator, and open the valve on the cylinder
completely.
2. Slowly turn the regulator adjustment screw until the desired pressure is shown on
the output gauge.
Note: on most regulators designed for draft beer, turning clockwise will increase
the output pressure, and turning counter-clockwise will decrease the output
pressure.
3. Open the shut-off valve on the regulator to allow gas flow from the regulator to
the keg coupler.
Note: You will hear the keg pressurizing the output needle will drop momentarily
until the pressure has equalized. Then the needle will return to the point you set it
at.
4. The keg coupler (usually the American Sankey Tap) is designed with a pressure
relief valve (PRV). Pull the ring on the PRV briefly to allow gas to vent.
Note: This will permit gas to glow through the regulator and help obtain a more
accurate reading on the output pressure gauge.
5. Re-check the output pressure on the regulator, and if necessary re-adjust using
step #2 until the desired pressure is shown.
Note: It is always wise to follow up any adjustment to the regulator with a brief
pull of the PRV ring to ensure an accurate output reading.
To Next Page
Loading...
Need help?
General
