EdgeStar CWR461DZ - Display and Control Board Access

- 12 -
3. DISASS
EMB
LY
2. Pull ou
t the cover board
（figure 37)
Figure 37
3. Tak
e out the LED light connector
（figure 38)
Figure 38
4. Lossen
the LED light five fixer.
（figure 39)
Figure 39
5.
The LED light is like below. (figure 40)
Figure 40
3-4 DISPLAY BOARD & CONTROL BOARD
(Models：CWR461DZ, CWR262DZ, CWR1101DZ,
CWR1551DZ)
1. Loosen four screws. (figure 41)
2. Pull out the electrical box.
Figure 41
Screw
3.
Unplug all cable connectors. (figure 42)
4. Press the plastic nail supporting the control board with
forefinger and thumb.
Figure 42
5. The control board is like below. (figure 43)
Figure 43
6. Disassemble the display board. (figure 44)
Figure 44
7. The display board is like below. (figure 45)
Figure 45
(Models：CWF340DZ)
1. Loosen free screws. (figure 46)
Figure 46