EdgeStar CWR461DZ - Sensor and Fan Component Access

- 16 -
3. DISASS
EMB
LY
2. The power board & transformer are like below. (figure 76)
Figure 76
(Models：CWR1551DD)
3. Loosen three screws. (figure 77)
Figure 77
4. The power board & transformer are like below. (figure 78)
Figure 78
(Models：CWR1431TZ)
5. Loosen three screws. (figure 79)
Figure 79
6. The power board & transformer are like below. (figure 80)
Figure 80
3-6 SENSOR & FAN
(Models：CWR262DZ)
1. Loosen six screws. Pull out the rear air duct cover.
(figure 8 1 )
fan
Screw
Sensor
Figure 81
2.
Loosen screw. You can replace the sensor ,heater & fan.
(figure 82)
heater
wire housing
screw
evaporator
defrost
sensor
Figure 82