EdgeStar CWR461DZ - Lamp

- 9 -
3. DISASS
EMB
LY
3-3 LAMP
(Models：CWR461DZ , CWR262DZ , CWR1101DZ,
CWR1551DZ ,
LED light in upper zone
1.
Loosen four screws. (figure 6)
screws
Figure 6
2.
Open the electrical box and remove four fixer on the PCB
board. (figure 7)
Figure 7
3. Unplug the led light connector. (figure 8)
connector
Figure 8
4.
Pull out the LED light. The LED light is like below. (figure 9)
Figure 9
LED light in lower zone
1. Loosen one screws. (figure 10)
Figure 10
2. Unplug the led light connector. (figure 11)
Figure 11
5. Loosen two screws. (figure 12)
Screw
Figure 12
6.
Pull out the LED light. The LED light is like below.
(figure 13)
Figure 8
Figure 13
(Models：CWF340DZ)
LED Light in upper zone
1. Loosen four screws. (figure 14)
Figure 14
connector