(A) With the shut-off valve on the regulator (#4) closed (lever in the 9 o’clock position), open the valve on the gas cylinder (#6) completely by turning it counterclock-
wise.
(B) Slowly turn the regulator adjustment knob clockwise until the desired pressure is shown on the pressure gauge on the top. By turning the knob clockwise it will
increase (+) pressure and counterclockwise will decrease (-) pressure. Under normal circumstances, we recommend setting the regulator at 10-12psi. NOTE: When
adjusting pressure from a high pressure to a lower pressure, you will need to release the higher pressure out by pulling the manual pressure release valve ring located
on the bottom right of the regulator.
(C) Once the desired pressure is set, open the shut-off valve by turning the lever down (6 o’clock position or parallel to the blue air line). Gas should now be flowing
from the regulator to the keg coupler. You will hear the keg pressurizing. The output needle will drop momentarily while the pressure is equalizing. Then, the needle will
return to the point you set it at.
(D) (Optional) Once you have all your pressure settings dialed in, screw down the locking ring (behind the main adjustment knob) clockwise until it firmly stops and is
against the body of the regulator. By doing this step it will stop the adjustment knob from increasing pressure. If however you need to increase pressure, loosen the
locking nut away from the body of the regulator and make any adjustment.
NOTE: Other conditions, such as altitude, beer type, and temperature may require some adjustment. It is always wise to follow up any adjustment to the regulator
with a brief pull of the pressure release valve ring on the regulator or coupler to ensure an accurate output reading.
A B C D
Warning:
This guide is provided for informational purposes only. It is provided as a supplement to the owner’s manual.
Please refer to the owner’s manual for a full discourse on installation, usage and maintenance. If you have any questions about the installation of
this appliance, feel free to contact EdgeStar service at 866.319.5473 or consult a qualified installer. Neither the manufacturer nor its distributors
shall be liable for any incidental, consequential, indirect, special, or punitive damages of any nature, including without limitation, lost revenues or
profits, or any other damage whether based in contract, tort, or otherwise.
Co2 cylinder comes empty due to HAZMAT restrictions. It will need to be filled locally at any air/gas
supplier prior to use.
Note:
This manual is intended as a guide for installation.
While there are many different ways to install this kit, we recommend you follow these instructions.
If you are uncomfortable in your ability to assemble this kit, seek professional assistance.
Remove the rubber cap from the
top of the coupler. Place the
neoprene washer (#10) located
under the rubber cap to the top of
the coupler (#7). Take the hex
nut from the end of the beer line
(#9) and screw it onto the top of
the keg coupler so that the
neoprene washer is between it.
To connect the keg coupler
(#7) to the keg (#8), first
make sure the black pull
handle of the keg coupler is
in the up position (45°
angle). Insert the keg
coupler into the valve on
top of the keg and turn
clockwise until it stops
about 90° to lock the
coupler into place. Now
pull the tap handle out
(away from the keg coupler
(#7) and push down until it
locks into position. Listen
for the “click” of the pull
handle when it shifts into
the final downward
position. The keg is now
tapped.
Connect Beer Line to Coupler Tap the Keg
Calibrating the Regulator
7
8
9
To Next Page
Loading...
