EdgeStar KC1000 User Manual

KC1000 Kegerator Installation Guide
1. Faucet Handle
2. Beer Tower
3. Drip Tray
4. CO
2 Regulator
5. CO
2 Tube
6. CO
2 Cylinder (supplied empty)
7. American Sankey Keg Coupler
8. Sixth Barrel (not included)
9. Beer Line
10. Neoprene Washer
11. Hose Clamp
12. Tower Plug
13. Tower Gasket
14. Screws (4)
Tools Needed:
- Wrench
- Flat Head Screwdriver
- Pair of Pliers/Clamp Crimper
*Additional replacement parts may be included
1
2
3
4
9
6
7
8
5
10
11
12
13
14
For additional information
visit edgestar.com

EdgeStar KC1000 Specifications

General

Brand	EdgeStar
Model	KC1000
Category	Kitchen Appliances
Language	English

Summary

EDGESTAR KC1000 Kegerator Installation Guide

Power On and Initial Setup

Ensure power is on and set the thermostat to the desired temperature.

Remove Tower Plug

Carefully remove the tower plug from the top of the unit.

Mount the Beer Tower

Attach the beer tower to the kegerator cabinet using screws.

Connect CO2 Regulator to Cylinder

Attach the CO2 regulator to the CO2 cylinder.

Connect CO2 Tube to Regulator

Connect the CO2 tube to the regulator's barb fitting.

Attach CO2 Tube to Coupler

Connect the CO2 tube's hex nut to the keg coupler.

Connect Beer Line to Coupler

Connect the beer line to the keg coupler with a neoprene washer.

Tap the Keg

Insert and lock the keg coupler into the keg valve.

Calibrate CO2 Regulator

Adjust regulator pressure for optimal beer dispensing.