EdgeStar KC2000 - User Manual

SAFETY PRECAUTIONS
Read all of the instructions before using this appliance. When using
this appliance, always exercise basic safely precautions, including the
following:
• This appliance is designed for household use only and not for commercial
use. Do not use the appliance for uses other than that for which it is
designed.
• Do not use the appliance if the power supply cord is damaged. If the
power supply cord is damaged, it must be replaced by a qualified
technician.
• This unit is designed to function on 115 Volts/ 60 Hz (110/115/120 Volts
acceptable) electrical circuits.
• This appliance is not designed for children. Never allow unattended
children to use this appliance.
• Unplug the appliance if it will not be used for an extended period of time.
• Unplug the appliance prior to cleaning.
• Set the appliance on a level surface away from direct sunlight and other
heat sources.
• This appliance is designed to function optimally in room temperature
environments (mid 70°s Fahrenheit).
• Do not move the unit while it is full.
• The power supply cord must be grounded.
• Never pull the power supply cord directly to disconnect the appliance.
Always pull the plug out of the socket.
• Never lift the appliance by the power supply cord or the dispensing tap.
• Keep the power supply cord away from heating surfaces.
• Service only by authorized technicians.
• Do not immerse the appliance or its power supply cord in water or any
other liquid.
• Do not cover the appliance or place anything on it.
• Do not insert any objects into the ventilation holes.
• Only use approved CO
2
cylinders. Make sure you read and understand all
the procedures for the CO
2
cylinders before installation.
• Cylinders contain pressurized CO
2
. Keep them away from heat, and store
in a dry and cool place. CO
2
cylinders should always be connected to a
regulator! Failure to do so may cause an explosion resulting in possible
death or injury when the cylinder valve is opened.
• Do not dispose of empty CO
2
cylinders in a fire. Never drop or throw a CO
2
cylinder.
• Clean this appliance regularly, and after every keg.
• If you are replacing an older appliance with this unit, take care to remove
the door of the old appliance before throwing it away. This will alleviate the
risk of child entrapment.
1

Summary

SAFETY PRECAUTIONS

Welcome and Thank You

Need Assistance

Guidance on contacting customer service for support.

UNPACKING ACCESSORIES AND INVENTORY

Additional Accessories

Lists optional items for the beer dispenser.

Proper Location

Recommendations for placing the appliance for optimal performance.

ASSEMBLY INSTRUCTIONS

Installing the Casters

Steps to attach the casters to the unit.

Installing the Beer Tower and Faucet

Instructions for assembling the beer dispensing tower.

Installing the Guardrail

Guide for attaching the guardrail to the cabinet.

Connecting the CO2 Cylinder to the CO2 Regulator and Installing the CO2 Cylinder Holder

Installing the Keg Coupler- Tapping the Beer

OPERATING YOUR BEER DISPENSER

Grounding Instructions

Essential safety guidelines for electrical grounding.

Setting the Correct Pressure for the CO2 Regulator

Guidance on setting CO2 pressure for optimal beer dispensing.

Setting the Regulator

Dispensing the Beer and Proper Drawing Technique

Beer Clean Glasses

Recommendations for cleaning glasses for best beer taste.

Understanding Beer Temperature

Temperature Control, Defrost, and Sounds

Beer Serving Guide

Tips and information on serving beer and keg yields.

CONVERTING THE BEER DISPENSER TO AN ALL-REFRIGERATOR

CLEANING & MAINTAING YOUR DRAFT BEER DISPENSER

TROUBLESHOOTING

LIMITED WARRANTY

EdgeStar KC2000 Specifications

General

Type	Kegerator
Temperature Range	32°F to 50°F
Refrigerant	R600a
Door Finish	Stainless steel
Cabinet Finish	Black
Door Swing	Reversible
Holds	Up to two 5-gallon kegs or one 1/2 barrel keg
Cooling System	Compressor
Power	115V, 60Hz
CO2 Tank	5 lb
Keg Compatibility	Full-size and pony kegs