The temperature control is located inside the unit in the upper left-hand corner. After
turning the unit on, you must wait 24 hours for the unit to cool properly. You may then
adjust the temperature setting based on your needs and preferences.
It is not usually necessary to defrost the beer dispenser. Ice that has deposited on the
evaporator is automatically defrosted when the compressor cycles off. The defrosted
water collects in the water drip tray located on the top of the compressor in the rear of the
unit and evaporates.
However, if the door is often opened or you are using the unit in a humid area, excessive
ice may build up on the evaporator. In this case, turn off the unit and allow the ice to melt
once your keg is empty. Be careful to soak up the excess water with a towel.
• Sizzling or popping sounds occur during the automatic defrost cycle.
• Bubbling or gurgling sounds and slight vibrations are the result of the refrigerant
circulating through the cooling coils.
• Cracking or popping sounds are caused by the expanding and / or contracting of
the cooling coils during the automatic defrost cycle.
• Dripping sounds occur as ice melts from the evaporator and flows into the water
collection tray during the automatic defrost cycle.
Understanding the Temperature Control Setting
Automatic Defrosting
Understanding Normal Operating Sounds
Beer Serving Guide
The following tips will help you serve the perfect beer.
What a half barrel (full keg) of beer provides you:
No. Glasses Glass Size
192 12 oz.
236 10 oz.
264 9 oz. Half Barrel (full size) Keg = 15.5 Gallons
290 8 oz. = 1984 Fluid Ounces
12
To Next Page
Loading...
Need help?
General
