ASSEMBLY INSTRUCTIONS
1. With the contents inside the cabinet removed set the beer dispenser on its side.
2. Insert each caster into the holes on the bottom corners of the cabinet. Screw the
casters in hand tight.
3. With all four casters tightened evenly, stand the unit in an upright position.
Note: Allow the beer dispenser to stand in an upright position for 8 hours before turning
on the power. This will ensure that the coolant has settled.
1. Remove the cabinet plug located on the top of the unit. Firmly grasp and twist and
pull upward. (It may help to open the cabinet and push up on the cabinet plug
with your hand from inside the unit).
Note: You should store this plug in a safe place as it is required to convert the beer
dispenser into a refrigerator
2. Take the tower and untangle the tubing. From the top of the unit, feed the tubing
through the hole and into the unit.
3. Align the black adapter at the bottom of the tower with the hole in the top of the
cabinet and insert and twist the tower until it locks into place (about ¼ a turn)
4. Align the faucet handle to be parallel with the beer tower with the spigot facing
downward and screw in the faucet counter-clockwise with your hands
5. Set the plastic drip pan into place below the faucet.
Installing the Casters
Installing the Beer Tower and Faucet
Installing the Guardrail
1. Snap the guardrail into the top of the cabinet’s guardrail pilot holes.
5
To Next Page
Loading...
Need help?
General
