5-1
5.0 VERIFYING AND TROUBLESHOOTING
The customer may need to verify that the system is receiving Mag Data. If all steps were setup correctly
and the magnetometer is connected there should have no errors showing in sonar. The data stream
should also be visible in Sonar. Use the following steps to open Sonar “Remote Desktop”:
1. Open Remote Desktop from Windows Taskbar:
Figure 5-1: Remote Desk Top Menu
2. The Sonar “Remote Desktop” will open; select “Misc” in the Sonar Toolbar, select “Serial Port
Information”.
Figure 5-2: Sonar Misc Menu
1) Right Click using mouse button
2) Left Click using mouse button to select “Remote Desktop”
“Serial Port Information”
To Next Page
Loading...
