ENGINE SEASTAR FRONT MOUNT SEASTAR FRONT MOUNT HYNAUTIC K-6
(Normal Use) (Aggressive Use - See Note 1) (Normal Use ONLY)
SINGLE ENGINE SINGLE CYLINDER SINGLE CYLINDER SINGLE CYLINDER
350 HP Max 350 HP Max 300 HP Max
75 MPH Max HC63xx Pro Cylinder (See Notes 2 & 3) 55 MPH Max
HC53xx Cylinder (See Note 2)
DUAL ENGINE SINGLE CYLINDER SINGLE CYLINDER SINGLE CYLINDER
NON COUNTER 450 HP Max Not Recommended 400 HP Max
ROTATING ENGINES 55 MPH Max 55 MPH Max
HC53xx Cylinder
HO60xx Tie Bar
DUAL CYLINDER DUAL CYLINDER DUAL CYLINDER
600 HP Max 700 HP Max 500 HP Max
55 MPH Max HC67xx Cylinders (See Notes 2 & 4) 55 MPH Max
HC53xx Cylinders HO67xx Tie Bar
HO60xx Tie Bar
DUAL ENGINE SINGLE CYLINDER SINGLE CYLINDER SINGLE CYLINDER
COUNTER ROTATING 600 HP Max Not Recommended 500 HP Max
55 MPH Max 55 MPH Max
HC53xx Cylinder
HO60xx Tie Bar
DUAL CYLINDER DUAL CYLINDER DUAL CYLINDER
600 HP Max 700 HP Max 500 HP Max
55 MPH Max HC67xx Cylinders (See Notes 2 & 4) 55 MPH Max
HC53xx Cylinders HO67xx Tie Bar
HO60XX Tie Bar
TRIPLE ENGINE DUAL CYLINDER DUAL CYLINDER NOT RECOMMENDED
ONE WITH COUNTER 900 HP Max 1050 HP Max
ROTATING ENGINE 55 MPH Max HC67xx Cylinders (See Notes 2 & 4)
HC53xx Cylinders HO67xx Tie Bars
HO60xx Tie Bar HA67xx Center Engine (See Note 2)
Bracket Kit
TRIPLE CYLINDER TRIPLE CYLINDER NOT RECOMMENDED
900 HP Max 1050 HP Max
55 MPH Max HC67xx Cylinders (See Notes 2 & 4)
HC53xx Cylinders HO67xx Tie Bars
HO60xx Tie Bar
3-4
Selection Guide
OUTBOARD–FRONT MOUNT
300HP
+
Outboard Installation
Recommendations
With the introduction of heavier, higher horsepower engines producing
more torque, Teleflex Marine has updated its recommendations across
various applications (single and multiple engines, different hull types,
etc.) Please read carefully to ensure that your current steering system
provides the best comfort versus performance available.
1 Teleflex has specific steering equipment for boats that are driven aggressively,
used in severe conditions or with more than 300 HP per engine.
2 ALL ENGINES over 300 HP and all boats that are driven aggressively must
use a high strength tiller bolt, kit part # HA5822. All front mount cylinders built
after June 15, 2007 will have this high strength bolt included in the box. High
strength tiller bolts can be identified by the marking “TFX –ARP” on the head
of the bolt (refer to NOTICE page 3-5).
3 HC63xx PRO Cylinders are designed for all those critical high speed, single
outboard engine boats, such as Bass, Flats combo Race/Ski and other
performance orientated boats capable of speeds in excess of 65 mph. For
optimal performance, the use of SeaStar PRO Kevlar Steering Hoses is
recommended.
4 HC67xx Tournament cylinders are designed for use with high powered
fishing/sport boats. If your application calls for dual or triple outboard engines,
is capable of speeds exceeding 55 mp/h and runs in open water, Tournament
Cylinders should be used.
To Next Page
Loading...
