4-2
Selection Guide
SYSTEM
CONFIGURATION
COMPONENT QTY MODEL PART PAGE
DESCRIPTION REQ # REF #
SINGLE & DUAL STERNDRIVE
(For dual sterndrive applications use
engine manufactures supplied tie bar.)
CYLINDER 1 SEE APPLICATION GUIDE
HELM 1 * SEASTAR I STANDARD (SEE NOTE 1) HH5271 9-6
** SEASTAR II-STANDARD (SEE NOTE 2) HH5272 9-6
OIL 3 SEASTAR OIL HA5430 11-1
TUBE/HOSE SEE NOTE 3 10-6
FOR EXTRA STEERING STATION ADD:
HELM 1 * SEASTAR I STANDARD (SEE NOTE 1) HH5271 9-6
** SEASTAR II-STANDARD (SEE NOTE 2) HH5272 9-6
FITTING KIT 1 ADD A STATION
- FOR SEASTAR 1 HELMS HF5502 10-11
- FOR SEASTAR II HELMS HF5501 10-10
OIL 1 SEASTAR OIL 11-1
EXTRA TUBE/HOSE SEE NOTE 3 10-6
Order Guide
OPTIONAL EQUIPMENT
BACK PLATE KIT (FOR STANDARD HELMS) HA5418 9-3
20 DEGREE WEDGE KIT (FOR STANDARD HELMS) HA5419 9-3
AUTOPILOT FITTING KIT (FOR ALL HELMS) HF5502 10-11
* TILT HELM-SEASTAR I HH5741 9-7
REAR MOUNT HELM-SEASTAR I HH5261 9-7
** TILT HELM-SEASTAR II HH5742 9-7
REAR MOUNT HELM-SEASTAR I HH5262 9-7
POWER ASSIST STEERING PA1200 2-1
1. Seastar I helms are the standard
recommendation for both non-power and
power steered applications.
2. Seastar II helms can be specified for
power steered applications where faster
steering response is desired. Review the
application chart on page 4-3 for
recommendations.
3. * For Seastar I systems: use 3/8" dia
nylon tubing ref part No. HT5_ _
(Refer to page 10-6)
* For Seastar II systems: Use t he
following option A or B
A) Outboard hose:
Hoses must be ordered in standard
lengths. They cannot be cut to length.
(Refer to page 10-2)
B) Copper tube:
3/8" diameter copper tube and hose kit
part No. HF5508 (Refer to page 10-6)
4. For dual stern drives – use the tie bar
supplied by the engine manufacturer.
NOTICE
These recommendations apply to
factory stock stern drives only.
Modified installations may require
a higher capacity steering system.
If in doubt, contact our technical
service for assistance.
STERNDRIVE STEERING
To Next Page
Loading...
