Edic CR2 - CR2 Included Accessories

8
1. Part# 334ACH-2
2 piece wand and reversible brush/squeegee head
assembly. For scrubbing on one side and picking
up water on the other. Connects to hose #4 on this
page.
2. Part# K13686
“Gulper” tool Used to extract large volumes of water.
Connects to hose #4 on this page.
3. Part# 00604-50HPA
50FT high pressure solution line. Connects to quick
disconnect on CR2 (#16 on page 4)
4. Part #J14062A
45 FT Vacuum Hose. Connects to vacuum hose
inlet barb on CR2 (#7 on page 4)
5. Part #J14039A
45 Blow hose. Connects to Exhaust port on CR2
(#13 on page 4)
6. Part #9000AC-1
High Pressure gun. Connects to hose #3 on this
page.
7. Hand Squeegee
Used to remove excess liquid from smooth vertical
surfaces.
8. Part # J13975
Faucet Adapter. Presses on to most standard faucets
to easily ll the CR2 without using buckets.
*NOT SHOWN- ACCESSORY MESH BAG
1
2
3
4
5
6
7
8
8