Optical/coaxial mode
• Press the "COAX"/"OPT" button on the remote control, or press the "volume/input" button on
the side panel of the active speaker to switch to coaxial/optical mode, and the red LED will be lit.
• Connect audio source (Set Top Box, Blu-ray player etc.) to the "OPT"/"COAX" input port on the
rear panel of the active speaker using fiber optic audio cable or coaxial cable (coaxial cable not
included).
• Play music on the connected device and adjust the settings to a desired level.
Note:
Only the standard PCM audio signals (44.1KHz/48KHz) function in optical/coaxial mode.
or
To Next Page
Loading...
