Section 10: Bluetooth Input
Pairing
1. Turn on speaker and switch to Bluetooth mode by pressing the Bluetooth button on the remote
control or press the master volume control on back panel of the active speaker.
2. Go to setup section on your source devices (mobile phones, tablets, etc.) and search for nearby
Bluetooth devices, you will find “EDIFIER S2000 Pro” in the list.
3. Pair your device with “EDIFIER S2000 Pro”.
4. Play audio tracks on your device and adjust the volume to a desired level.
Other operations
5 After pairing, using the pair record on your source device to re-connect to the speaker;
6 Bluetooth of the product will be powered off after switching away from Bluetooth mode, so in other
audio mode Bluetooth connection can not be made.
7 When switch to Bluetooth mode, the speaker will try to connect the last connected Bluetooth source
device.
8 To disconnect Bluetooth, press and hold the master volume control for about 2 seconds.
Note:
1. Bluetooth connectivity and compatibility may be different among different source devices,
depending on the software versions of source devices.
2. To enjoy the full Bluetooth functions of this product, please ensure your mobile device
supports A2DP and AVRCP profile.
3. PIN code for connection is “0000” if needed.
To Next Page
Loading...
