EDIFIER W100T User Manual

Charge
Left & Right connection (Connect to another W100T earbuds)
x5 x5
IndicatorIndicator
x2 x2
IndicatorIndicator
1. Earbuds must disconnect to any devices. Respectively tap 5 times the touch panel on both earbuds to
cancel Left & Right connection. Blue LED will be steady lit. Upon connection is canceled, place the
earbuds back in the case.
2. Taken out of the case and disconnected to any devices. Respectively tap 2 times the touch panel on both
earbuds to start Left & Right connecting. Blue LED will blink rapidly.
3. Upon connection is successful select "EDIFIER W100T" in your device setting to connect.
Earbuds
1. When hearing low battery prompt tone, please place the earbuds in the
case for charging.
2. Red LED is steady lit when charging and off when fully charged.
Charging case
1. Please connect the case to power source with the included Type-C
charging cable for charging.
2. Red LED is steady lit when charging and off when fully charged.
Red LED
Input: 5V 200mA(Earbuds)
5V 1A(Charging case)

EDIFIER W100T Specifications

General

Brand	EDIFIER
Model	W100T
Category	Wireless Headphones
Language	English