EasyManua.ls Logo

EdilKamin Idrotech - Page 33

EdilKamin Idrotech
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 33 -
EVERY SEASON (by the DEALER)
Before carrying out any maintenance, disconnect the device from the mains power supply.
The authorized DEALER will give you a maintenance booklet after the rst Idrotech boiler-stove ignition.
General internal and external cleaning.
Carefully clean heat exchange pipes.
Carefully clean and descale combustion chamber and corresponding compartment.
Clean motors and mechanically inspect the play and fastenings.
Clean smoke duct (replace gasket on the smoke outlet pipe) and smoke extractor fan compartment.
Check expansion tank.
Check and clean circulator pump.
Check detectors.
Check and replace the electronic circuit board clock battery if necessary.
Clean, inspect and descale ignition heating element compartment and change heating element if necessary.
Clean/check display-control panel.
Visually inspect electric cables, connections and power cord.
Clean pellet hopper and check screw feeder-gearmotor assembly play.
Check and replace the door seal if necessary.
Test screw feeder loading, ignition, operation for ten minutes, and shutdown.
Failure to carry out maintenance leads to forfeiture of the guarantee.
If the stove is used frequently, it is advisable to clean the smoke duct every 3 months.
For ue maintenance methods, also bear Italian standard UNI 10847/2000 “single ue systems for liquid and solid-fuelred
generators” in mind. Servicing and checking.
SUITABLE ACCESSORIES FOR EXCELLENT CLEANING
GlassKamin
ash vacuum bin
ENGLISH
ENGLISH

Related product manuals