Need help?Do you have a question about the Edimax ER-5390P and is the answer not in the manual?
General| Standards | IEEE 802.3, 802.3u, 802.3ab, 802.3x |
|---|---|
| Data Transfer Rate | 10/100/1000 Mbps |
| Jumbo Frame | 9KB |
| Power Input | 100-240V AC, 50/60Hz |
| Operating Temperature | 0°C to 40°C |
| Humidity | 10-90% RH (Non-condensing) |
Lists key features like IEEE 802.3 compliance, uplink mode switch, BNC port, and fault isolation.
Details standards, ports, dimensions, weight, power, and operating conditions.
Describes the front and rear panel layout including ports, LEDs, and connectors.
Explains the function of Power, Collision (COL), and Link/Activity (LNK/ACT) LEDs.
Specifies conditions for installation and operation, avoiding heat and moisture.
Details how to connect network cables to devices and the hub, mentioning cable length limits.
Explains how to use Port 1 for uplink connection to extend the network segment.
Steps to check power adapter connection and hub power jack.
Checks device power, cable connections, and cable compliance.
Verifies uplink cable connection to the correct ports and compliance.
Advises removing cables to isolate collisions and checking cable quality.
To Next Page
