Need help?Do you have a question about the Edimax EW-7303APn v2 and is the answer not in the manual?
General| 2.4 GHz | Yes |
|---|---|
| Modulation | - |
| Frequency band | 2.4 - 2.484 GHz |
| Number of users | - user(s) |
| Channels quantity | - channels |
| Networking standards | IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3u |
| Maximum outdoor range | 1000 m |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Maximum data transfer rate | 150 Mbit/s |
| Internal | No |
| Certification | CE, FCC, RoHS |
| WAN connection | Ethernet (RJ-45) |
| Ethernet LAN (RJ-45) ports | 1 |
| VPN support | IPSec, L2TP, PPTP |
| Security algorithms | 802.1x RADIUS, TKIP, WDS, WEP, WPA, WPA2, WPS |
| Operating temperature (T-T) | -20 - 70 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
| Input current | 1 A |
| AC input voltage | 12 V |
| Flash memory | 4 MB |
| Internal memory | 32 MB |
| Antenna gain level (max) | 12 dBi |
Weight and Dimensions| Depth | 59 mm |
|---|---|
| Width | 77 mm |
| Height | 225 mm |
| Weight | 250 g |
Illustrates the main router and the first EW-7303APn v2 unit in Building 1.
Shows the second EW-7303APn v2 unit in Building 2 acting as a repeater.
Connects the first unit to the main router and sets it to Gateway/AP mode.
Select DHCP (Auto Config) for the WAN connection type on the first unit.
Set SSID, security mode (WPA2-PSK), and pre-shared key for the first unit.
Reboot the first EW-7303APn v2 after saving its configuration changes.
Connect a computer to the second unit and prepare it for repeater mode setup.
Modify the second unit's IP address to 192.168.2.2 to prevent conflicts with the first unit.
Navigate to Wireless Settings > Basic and select 'Repeater' for the wireless mode.
Scan for the first unit's network and enter the correct wireless security key.
Secure the second EW-7303APn v2 with a wireless password/key for enhanced security.
Answers common questions regarding signal strength and bandwidth performance in repeater setups.
To Next Page
