8
3. Network Card Installation
Please follow the following instructions to install your new USB wireless
network card:
3.1 Hardware Installation
EW-7318Ug / EW-7318USg / EW-7717Un / EW-7718Un
1. Fasten the antennas to the antenna connectors on the network card by
clockwise direction. (EW-7318USg only)
2. Insert the USB wireless network card into an empty USB 2.0 port of
your computer when computer is switched on.
Never use force to insert the card, if you feel it’s stuck, flip the
card over and try again.
3. The following message will appear on your computer, click ‘Cancel’.
To Next Page
Loading...
