iv Programming Manual
Document history
IRC-3 Programming Manual P/N 250060
Revision Status
Revision
Program Manual Date Reason for Change
1.1 1-31-89 Initial release - UL listed.
1.4 A 6-1-89 Added: Coder programming.
2.0 B 10-16-89 Added: RZB12-6, verification on standard zones and M500MF, M501MF
modules, test actions, DOS shell.
2.1 C 2-26-90 Added: Actions 9011 thru 9020 for 1st thru 10th zone/device in alarm;
Data line baud rate setting; Job name identifier for sensitivity reports;
System communications class type; modem call back feature (not yet
supported in CM1N firmware).
2.3 D 10-1-90 (Pre-release for CM1N/2N firmware Rev. 1.3) Added: Adjustment for
daylight savings time; 600 event history file in RAM; External command
port; USA/European mode select; Remote downloading to CM2N from
CM1N; Watchdog reset counter in history; Enhanced coder support;
Variable system reset time based on configuration size; Trouble buzzer
disable when status zones are defined (action 9010); Expanded
maximum # of defined panels to 56 (52 Remote) with CM1NX or RMDP-
1NX; Dry contact option for RZB12-6 circuit IN/OUT 3 and IN/OUT 4.
2.4 E 2-15-91 (CM1N/CM2N firmware Rev. 2.0) CM2N regenerative network (Action
9006,9021-9052,9061-9092);VDU-3 support by CM2N; Variable baud
rate for panel-to-panel communication; Sensitivity/alternate sensitivity
selection by time/keypad; External database expander CM2N (addr.=
62); Automatic SANCOM function as main control point.
2.4 E.1 4-1-91 (CM1N/CM2N firmware Rev. 2.1) Sensitivity/alternate sensitivity
selection by time/keypad; Sensor maintenance alert notification (action
9008).
2.5 F 11-6-91 "A"/"B" series BRK device support; Reset/alarm silence Inhibit;
Broadcast bell-code; Update RS-232 communications protocol.
2.6 G 9-8-92 Replace all "FAST" references with "EST"; Correct alternate sensitivity
problem; Remove unused CM1N and CM2N menu items; Correct
RZB12-6 I/O 1-4 supervisory zone problem.
2.6 H 5-13-93 (CM1(N)(NX)/CM2(N)(D) firmware Rev. 3.0) Improved ZAS response
time; Added action 9009; Upgraded external command port protocol;
Improved alarm silence & reset inhibit timer operation; Revised
Canadian and European operating modes; Added CM2ND
programming information; Updated VDU-3 information.
4.0 1.0 02-15-95 Converted manual from WordPerfect to MS-Word format;
Reformatted text; Added screens for ZAS-2 configuration; Added
ZAS-2 worksheets; Updated other worksheets.
4.0 2.0 05-24-95 Added regenerative programming section.
4.0 3.0 06-20-95 Added ZRM programming, ZB8-5/3.
5.0 3.5 07-97 Layout and content changes.
To Next Page
Loading...
