To Next PageTo Next Page
Need help?Do you have a question about the Edwards 2400 Series and is the answer not in the manual?
General| Product Series | 2400 Series |
|---|---|
| System Type | Conventional Fire Alarm Control Panel |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Manufacturer | Edwards |
| Max Notification Appliance Circuits (NACs) | 4 |
| Power Supply | 120/240VAC, 50/60Hz |
| Battery Standby | 24 hours |
| Auxiliary Power Output | 24VDC, 500mA regulated |
| Relay Outputs | 2 Form-C (Alarm, Trouble) |
| Certifications | UL, FM, CSFM |
| Humidity Range | Up to 93% RH, non-condensing |
| Enclosure Type | Steel |
| Dimensions (Typical) | 14.5" H x 12.5" W |
Verify System Trouble LED flashes and Trouble Buzzer sounds upon switch activation.
Observe Power LED, System Trouble LED, and Zone Trouble LEDs for correct status after reset.
Initiate programming with Reset, observe LED changes, and use Trouble Silence to select zone types.
Chart detailing initiating device circuit zone types and their corresponding Zone Trouble LED color codes.
Select which Indicating Appliance Circuits (IACs) are operated by the programmed zone.
Program each initiating device circuit and its associated IACs by repeating steps and pressing Reset.
Configure Circuit 1 as either Silenceable or Non-Silenceable using the Alarm Silence Button.
Select the desired output rate for Indicating Appliance Circuits using the Trouble Silence Button.
Program Circuit 2 mode and rate, then verify LED status after programming Circuit 1.
Set the timer that prevents panel silence function until a programmed time limit is reached.
Configure the automatic silence timer settings and observe corresponding Alarm Silenced LED codes.
Choose whether Auxiliary Power remains energized or de-energizes on reset of specific modes.
Procedure to exit programming mode by moving the slide switch to the off position.
