© 2017 United Technologies Corporation
All rights reserved.
This document may not be copied in whole or in part or otherwise
reproduced without prior written consent from UTC Fire & Security,
except where specifically permitted under US and international
copyright law.
Document number: 387348-EN Revision: 007
The SIGA-REL name and logo are trademarks of United
Technologies Corporation.
Other trade names used in this document may be trademarks or
registered trademarks of the manufacturers or vendors of the
respective products.
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications.
You are cautioned that any changes or modifications not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
European Union
directives
The European directive “Waste Electrical and Electronic Equipment”
(WEEE) aims to minimize the impact of electrical and electronic
equipment waste on the environment and human health. For proper
treatment, recovery, and recycling, you can return the equipment
marked with this symbol to your local supplier upon the purchase of
equivalent new equipment, or dispose of it in designated collection
points. Further information can be found on the following website:
www.recyclethis.info.
European representative for manufacture: United Technologies
Corporation, Kelvinstraat 7, 6003 DH Weert, Netherlands.
Information in this manual applies to the following versions of
system development or configuration software.
EST2 Version 3.2
EST3 Version 3.6
QS-CU Version 1.8
For contact information, see www.edwardsfiresafety.com.