SIGA-REL Technical Reference Manual 33
Chapter 3
Programming
Summary
This chapter contains configuration and programming instructions for system
programmers. Read the configuration and programming topics that apply to your
fire alarm system.
SIGA-REL programming is almost identical for all systems. The greatest
differences exist in the rules required and the configuration of AND groups. The
SIGA-REL programming steps require strict adherence. Follow each instruction
carefully.
Content
Programming the SIGA-REL in the 2-SDU 35
Adding the SIGA-REL to the database 35
Creating an abort confirmation LED 37
Programming an AND group 37
Reconciling the Signature map 37
Writing rules for the SIGA-REL 38
Programming the SIGA-REL in the 3-SDU 39
Adding the SIGA-REL to the database 39
Programming an AND group 41
Writing rules for the SIGA-REL 41
Programming the SIGA-REL in the QS-CU 43
Minimum system requirements 43
Step 1: Read this first 43
Step 2: Add the abort and manual release switch circuits 44
Step 3: Add the two releasing circuits 44
Step 4: Add the two prerelease circuits 45
Step 5: Create a prerelease response 46
Step 6: Create an AND group release response 46
Step 7: Create a manual release response 47
Step 8: Supervise the service disconnect switch 47
To Next Page
Loading...