64
MV-2520-01-2020
.
eeese-aircare.com © All rights reserved by Eeese Air Care APS
DK
Pass the composite pipe C through the rail on the back of the
unit, as illustrated to the right - E. Note that the pipe must be
correctly positioned when pulling it through the rail.
The left end of the composite tube (D), is set into
place with the provided rail (F).
Gently push the rail to the left until the holes in the rail and tube overlap (K). So that the
supplied screw can be inserted (L).
At the opposite end of the rail (J), there is a hole for the supplied screw bracket (M) as
shown in the picture N. Lift the screw bracket enough to allow the groove of the other rail
(to the right of image O) to pass through.
E
F
LJ K
NM O
To Next Page
Loading...
