66
MV-2520-01-2020
.
eeese-aircare.com © All rights reserved by Eeese Air Care APS
DK
Automatic on/o timer function [timer button]
Press the timer button (A) to select the hour you want the timer to turn o/turn on the
device. Pressing the up (B) and down (C) button changes the setting by 1 hour in the
range of 00-24.
Pressing the timer button 2 times cancels the timer settings.
The auto-o setting is cancelled if the device is switched o and on again.
Cooling mode [Cooling button]
Alba is preset for cooling (A) with low blow speed (B) when you start the unit. You can
choose between low blow speed (B) and high blow speed (C).
Remember to install the exhaust pipe when the cooling function is used.
It will take 3 minutes before the compressor starts after the unit has been
switched on. This protection function helps to prolong the life of the unit.
The unit's air ventilation on the back has a sensor that stops the device if it gets
too cold during dehumidication or cooling. The device starts automatically when
the temperature reaches a safe level.
A B C
A B C
To Next Page
Loading...
