eeese Hugo - Page 14

MV-2556-2557-08-2022 eeese-aircare.com © All rights eeese air care aps
97
UK
The humidity is
not reducing
The dehumidier has not been
used long enough.
Be patient and wait
The ambient temperature is too
low
Reduce the ambient
temperature
The surrounding humidity level is
too low
This is normal. You can dou-
blecheck with a hydrometer
The ambient humidity level is
lower than the desired humidity
level set
This is normal. You can
doublecheck with a
hydrometer
The air lter frame is dirty Clean the pre -lter frame
Dehumidier is
blowing out warm
air
The dried air is passed over heat-
ing coils before it is blown into
the room as part of the dehumidi-
fying process
This is normal, a dehumidier
is not an air cooler
Water on oor
There is residual water in tank,
and the device is lurched too
much by moving
Be careful when moving the
tank
Water in tank
overows
The water tank may be damaged
Contact our eeese service
line
Float for water auto-sensor is not
in place
Internal drainage passage is
blocked or obstructed
The dehumidier
is noisy
The pre-lter is blocked or the
device is on an uneven surface
Clean the pre-lter or put the
device on a at surface
Error code
E1: Temperature sensor error
E2: Humidity sensor error
Contact our eeese
service line