eeese Otto - Cleaning the Pre-Filter Frame; Storage

98
MV-2552-2553-2554-08-2022 eeese-aircare.com © All rights eeese air care aps
UK
7. Cleaning the Pre-lter Frame
1. Remove the pre-lter frame from the back.
2. Wash the pre-lter frame carefully in warm water, use a mild detergent if necessary.
Note: DO NOT wash the pre-lter frame in a dishwasher.
3. Rinse the pre-lter frame in clean water and let it dry before reinserting it.
4. Fit the pre-lter frame back onto the unit
Note: DO NOT use the dehumidier without the pre-lter frame in place.
The HEPA lter cannot be cleaned and needs to be replaced once a year.
8. Storage
If the dehumidier will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the tank, make sure the tank and the
dehumidier is completely dry. This may take a couple of days.
2. Clean the air lter.
3. Check the dehumidier for perfect condition to ensure a safe use of it after a long
period of storage.
4. Pack the device with the suitable packaging.
5. Store the dehumidier in a dust-free location, and out of direct sunlight. Preferably
covered with a sheet of plastic.