EemaX EX380T2T2 User Manual

ELECTRIC INSTANTANEOUS WATER HEATER
INSTALLATION GUIDE AND OWNERS MANUAL
IF YOU REQUIRE ANY HELP OR HAVE ANY QUESTIONS RELATING TO THE
INSTALLATION OR PERFORMANCE OF THIS HEATER, PLEASE CALL OUR
TECHNICAL SERVICE DEPARTMENT TOLLFREE : 1-800-543-6163.
HAVE THE INFORMATION LISTED BELOW BEFORE CALLING :
SERIAL NO. MODEL NO. EX380 INSTALLATION DATE
EEMAX “FOUR MODULE, SINGLE PHASE”
WATER HEATERS
MODELS COVERED:- EX380T2T2 -220/240 V
EX380T4 - 220/240 V
SPECIAL_________,______V
READ THE GENERAL SAFETY SECTION BEGINNING ON THE INSIDE COVER
AND THEN THIS ENTIRE MANUAL BEFORE INSTALLING OR OPERATING THIS
WATER HEATER. IF YOU DON’T FOLLOW THE SAFETY RULES, THE UNIT WILL
NOT OPERATE PROPERLY AND IT COULD CAUSE DEATH, SERIOUS BODILY
INJURY AND/OR PROPERTY DAMAGE. READ ALSO THE ENCLOSED
WARRANTY CARD. WARRANTY OF THIS WATER HEATER WILL DEPEND ON
PROPER INSTALLATION AND OPERATION. THE WARRANTY SHALL BE VOID IF
THE DESIGN HAS BEEN ALTERED IN ANY WAY WHATSOEVER. THE
MANUFACTURER OF THIS HEATER WILL NOT BE LIABLE FOR ANY DAMAGES
BECAUSE OF FAILURE TO COMPLY WITH THE INSTALLATION AND
OPERATING INSTRUCTIONS OUTLINED ON THE FOLLOWING PAGES.
THE INSTALLATION MUST CONFORM WITH THE INSTRUCTIONS IN THIS
MANUAL; ELECTRIC COMPANY RULES; AND THE LOCAL CODES, OR IN
THE ABSENCE OF LOCAL CODES, WITH THE LATEST EDITION OF THE
NATIONAL ELECTRICAL CODE. THIS PUBLICATION IS AVAILABLE FROM
YOUR LOCAL GOVERNMENT OR PUBLIC LIBRARY OR ELECTRIC COMPANY
OR BY WRITING UNDERWRITERS LABORATORIES, 333 PFINGSTEN ROAD
NORTHBROOK, IL, 60062.
WARNING
1

EemaX EX380T2T2 Specifications

General

Brand	EemaX
Model	EX380T2T2
Category	Water Heater
Language	English

Summary

General Safety

Key Safety Warnings

Critical warnings regarding grounding, installation, voltage, and electrical shock hazards.

Mounting the Unit

Pressure and Temperature Relief Valve (PTRV) Requirements

Guidance on PTRV installation based on UL and local code requirements.

Plumbing Hook-Up

Plumbing Connection Guidelines

Instructions on pipe connection, leak testing, and air purging for proper hook-up.

Electrical Hook-Up

Specifications and Wiring Requirements

Details on model specifications, voltage, amperage, and circuit breaker requirements.

Commissioning Your Heater

T2T2 Model Commissioning and Temperature Adjustment

Steps for T2T2 model setup, indicator light behavior, and temperature control adjustment.

Troubleshooting

Symptom A: No Heat Indicator Light Off

Troubleshooting steps for issues when the heat indicator light is off.

Symptom B: No Heat or Low Temperature with Indicator Light On

Troubleshooting steps for issues with heat or temperature while the light is on.

Replacement Parts Diagram

Component Identification

Diagram identifying key internal components and contact information.