eesens SHIELD - Tap and Hold Device Operations

12 / 24 SHIELD-SET-MANUAL-EN-Rev.02
Tail Light
Tap
1 tap: Check battery capacity
2 taps: Enter tapcode to disarm tail light
Tap and
hold
2 seconds: Turn off ride light manually
3 seconds: Paring mode to link new controller
5 seconds: Turn on/off Carry Mode
>10 seconds: Restart device
Sensing Controller
Tap
1 tap: Check battery capacity
3 taps: Enable “Find my bike”. Sensing
controller will trigger Tail Light to blast loud
sound and bright light, helping you to locate
your bike.
Tap and
hold
3 seconds: Paring mode to link new Tail Light
5 seconds: Turn on/off Carry Mode
>10 seconds: Restart device
Status Indicators
System
3 flashing red: input wrong actions
Repeated flashing red: rebooting system
5 flashing red/green: enter/exit Carry Mode
2 flashing yellow: start entering disarm
tapcode