20
When you open the sensor note the thin black wire, it is the sensors
antenna. Do not break it. Broken antenna wire caused by replacing
battery is not covered under warrantee.
Remove the cover and remove the sensor from the
anti-theft housing.
Use the wrench to hold the inner sensor and remove the upper
portion of the sensor housing.
Take the battery out.
Replace a new CR1632 battery cell, ensure the positive + is facing
upwards. Note the illustration above. Depending on how long the
battery was low you may have to reprogram the sensor.
Check that the water-proof rubber seal is in its proper position. Screw
the sensor cap back on. Reinstall the anti-theft housing.
Flow Through Sensor Battery replacement
When you hear the low battery tweet, the next time you park the
vehicle watch the monitor. Every time the monitor comes to that
sensor the monitor will tweet.
Install CR1632 battery which operates at -40°F to 176°F. These can be
purchased at many hardware stores, Home Depot or large Walmart’s
on-line at eBay, Amazon.com or on our site www.eezrvproducts.com.
Use the hex/Allen wrench provided to remove the anti-theft screw
and take of the sensor. Then use a small Philips screw driver to take
the cap marked “EasyTire” off. Under the cap is the battery. Remove
it and replace it with a new CR1632 battery. Depending on how long
the battery was low you may have to reprogram the sensor.
To Next Page
Loading...
