8
sensor take some clear nail polish and paint over the number. This will
help ensure it stays on in inclement weather conditions.)
3. On the diagram on the last page of this manual assign the
numbered sensors to each tire as they will be put on your rig and
tow vehicle. Also fill in the tire pressures for each axel.
4. Program the alarm parameters using STEP 1 setting your system
alarm parameters.
5. Program each sensor to the monitor using STEP 2 programing
sensors to the monitor.
STEP 1: SETTING YOUR SYSTEMS ALARM
PARAMETERS
Refer to the diagram on the last page of this manual where you wrote
the “HIGH and LOW” pressure for each axel.
1. Next to each axle write down what your tire pressure is by axle and
calculate what your alarm setting will be.
2. High-Pressure setting will be (20% above axle tire pressure).
3. Low-Pressure setting will be (10% below axle tire pressure).
To Next Page
Loading...
