Pneumatically operated breastbone saw EFA 57
Operating instructions EN
Part no. 110 885 700 – Rev. 00 – 01.2020
19 of 34
5.2 Handling
The EFA pneumatically operated breastbone saw is held with both hands while the saw is suspended from the
spring balancer and is guided to the breastbone of the suspended carcass.
The EFA pneumatically operated breastbone saw must not be switched on before the operator has read these
operating instructions and the saw has been connected correctly, see chapter 2 – Safety.
Caution! Machine damage and hazard to third parties due to improper use!
Use the machine properly.
Warning! Cutting hazard: Limbs can be severed!
Never reach into the area of the running saw blade.
Attention!
Wear eye protection or protective goggles when working!
5.3 Switching on the EFA pneumatically operated breastbone saw
The EFA pneumatically operated breastbone saw is equipped with a valve lever (1) for switching on the
compressed air flow.
Make sure that the EFA pneumatically operated breastbone saw is connected to the local compressed air
network (supply pressure 7 bar).
Perform a function test before starting work.
Hold the device firmly by its handles (2, 3).
To switch on, use your index and middle fingers to operate the operating lever.
Attention!
Device damage!
Improper handling will lead to increased wear!
The machine must not be switched on unless the saw blade has been correctly mounted and
is firmly seated.
1
3
2
To Next Page
Loading...
