Efco DS 2700 - Brush Cutter Maintenance; Maintenance Chart and Attachment Care

en
24
MAINTENANCE
Maintenance Chart
Please note that the following maintenance intervals apply for normal
operating conditions only. If your daily work requires longer than
normal or harsh cutting conditions are present, then the suggested
intervals should be shortened accordingly.
Before Each Use
Monthly
If Damaged or Faulty
As Required
6 mouths or 50 hrs.
1 year or 100 hrs.
Complete Machine Inspect (Leaks, Cracks, and Wear)
x
Clean after finishing daily work
x
Controls (STOP button, Choke Lever,
Throttle Trigger, Trigger interlock)
Check Operation
x
Fuel Tank Inspect (Leaks, Cracks, and Wear)
x
Clean
x
Fuel Filter and tube Inspect
x
Clean, Replace Filter Element
x x
Cutting Attachments Inspect (Damage, Sharpness, and
Wear)
x
Check Tension
x
Sharpen
x x
Bevel Gear Inspect (Damage, Wear and
Grease Level)
x x
Cutting Attachments Guard Inspect (Damage, and Wear)
x
Replace
x x
All Accessible Screws and Nuts (Not
Adjusting Screws)
Inspect
x
Retighten
x
Air Filter Clean
x x
Replace
x x
Cylinder Fins Clean
x
Starter System Vents Clean after finishing daily work
x
Starter Rope Inspect (Damage, and Wear)
x
Replace
x
Carburetor Check Idle (Cutting Attachments
must not
rotate at idle)
x
Spark Plug Check Electrode Gap
x
Replace
x x
Vibration Mounts Inspect (Damage, and Wear)
x
Replace by Dealer
x x
Cutting Attachments nuts and
screws
Check that the locking nut of the
cutting equipment is tighten
correctly
x