en
29
MAINTENANCE
Maintenance Chart
Please note that the following maintanance intervals apply for normal operating conditions
only. If your daily work requires longer than normal or harsh cutting conditions are present the
suggested intervals should be shortened accordingly.
Before Each Use
After Each
Refueling Stop
After Finishing
Daily Work
Weehly
Monthly
If Damaged or
Faulty
As Required
Complete Machine Inspect (Leaks, Cracks, and Wear)
X X
Clean
X
Controls (Ignition Switch, Choke Lever,
Throttle Trigger, Trigger Interlock)
Check Operation
X X
Chain Brake Check Operation
X X
Clean and Oil
X
Check by Dealer
X X
Fuel Tank Inspect (Leaks, Cracks, and Wear)
X X
Clean
X
Oil Tank Inspect (Leaks, Cracks, and Wear)
X X
Clean
X
Fuel Filter Inspect
X
Clean, Replace Filter Element
X
Every 6
Months
Chain Lubrication Check Output
X X
Saw Chain Inspect (Damage, Sharpness, and Wear)
X X
Check Tension
X X
Sharpen (Check Gauge Depth)
X X
Guide Bar Inspect (Damage, and Wear)
X X
Clean Bar groove and Oil Passages
X
Rotate
X
Lubricate Sprocket Nose
X
Deburr
X
Replace
X X
Rim Sprocket Inspect (Damage, and Wear)
X
Replace
with every
new chain
Clutch Drum Inspect (Damage, and Wear)
X
Replace
X
Chain Catcher Inspect (Damage, and Wear)
X X
Replace
X X
Spark Arrestor Screen (In Muffer) Inspect (Damage, and Wear)
X
Clean or Replace
X X
All Accessible Screws and Nuts
(not Adjusting Screws)
Inspect
X
Retighten
X
Alr Filter Clean
X X
Replace
X
Every 6
Months
Cylinder Fins Clean
X
Starter System Vents Clean
X
Starter Rope Inspect (Damage, and Wear)
X
Replace
X
Carburetor Check Idle (Chain must not rotate at Idle)
X X
Spark Plug Check Electrode Gap
X
Replace
X
Every 6
Months
Vibration Mounts Inspect (Damage and Wear)
X
Replace by Dealer
X X
To Next Page
Loading...
