18
en
OPERATION
Bucking Spike
WARNING: Your chain saw is fitted with a bucking
spike (A, Fig. 34). The bucking spike is very sharp
and can cause injury. Be extremely careful when
working near the bucking spike.
WARNING: Removal of the bucking spike will violate
the saws compliance of SAE J335 and other stan-
dards. See Safety-State and Local Requirements.
Fueling (Do Not Smoke!) (Fig. 37)
This product is powered by a 2-cycle engine and requires pre-
mixing gasoline and 2-cycle oil. Pre-mix unleaded gasoline and 2-
cycle engine oil in a clean container approved for gasoline
(Fig.
35).
RECOMMENDED
FUEL: THIS ENGINE IS CERTIFIED TO OPE-
RATE ON UNLEADED GASOLINE INTENDED FOR AUTOMOTI-
VE USE WITH AN OCTANE RATING OF 89 ([R + M] / 2) OR
HIGHER
(Fig. 36).
Mix 2-Cycle Engine Oil with gasoline according to the instructions
on the package. If 2-Cycle Engine Oil is not available, use a high
quality 2-cycle engine oil for correct mixing proportion see table
below
(pag. 19).
CAUTION: DO NOT USE AUTOMOTIVE OIL OR
2-CYCLE OUTBOARD OIL.
CAUTION: Never use a fuel with an alcohol percentage
higher than 10%; gasohol up to 10% alcohol or E10
fuel are acceptable.
When using an Oxygenated Gasoline a good practice of Fuel
Management is necessary.
Gasoline Oxygenated with alcohol readily takes/up water when it
is present; the water may be condensed out of humid air or be a
contaminant in the fuel system, including tank.
CAUTION:
- Match your fuel purchases to your consumption;
don’t buy more than you will use in one or two
months;
- Store gasoline in a tightly-closed container in a
cool, dry place.
The use of Oxygenated Gasoline may cause the occurrence of
vapor-lock easier.
34
35
36
37
Efco 3700 Inglese 15-02-2007 15:18 Pagina 18
To Next Page
Loading...
