EasyManuals Logo

Efco MT 7200 User Manual

Efco MT 7200
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
en
33
BPMR8Y
Starter Unit
Use a brush to keep the cooling vents of the starter assembly free
and clean of debris (Fig. 94).
WARNING: The coil spring is under tension and
could fly apart causing serious injuries. Never try to
disassembly or modify it.
Engine
Clean the cylinder & flywheel fins with compressed air or a brush
periodically (Fig. 95). Dangerous overheating of engine may occur
due to impurities on the cylinder.
WARNING: Never run the saw without all the parts,
including the drivecase cover and starting housing,
securely in place.
Because parts can fracture and pose a danger of
thrown objects, leave repairs to the flywheel and
clutch to trained Servicing Dealers.
Spark Plug
This engine uses a NGK BPMR8Y with .02” (0.5 mm) electrode gap
(Fig. 96). Use an exact replacement and replace every six months
or more frequently, if necessary.
WARNING: Never test the ignition system with
ignition wire connector removed from spark plug
or with unseated spark plug, since uncontained
sparking may cause a fire. A loose connection
between spark plug terminal and ignition wire
connector in the boot may create arcing that could
ignite combustible fumes and cause a fire.
Use only resistor type spark plugs of the approved range.
Factors such as:
- too much oil in fuel mix;
- dirty air filter;
- unfavourable running conditions, e.g. operating at part load;
may result in rapid deterioration of the spark plug.
Spark Arresting Muffler
The chainsaw is provided with a Spark Arrester System p.n.
098000147 (Fig. 97-98) complying with the requirements of SAE
J335 standard; you can check the p.n. of the Spark Arrester
System on the muffler itself.
WARNING: A faulty or altered spark arrester system
screen can create a fire hazard.
Through normal use the screen can become dirty and should be
inspected weekly and cleaned as required.
To clean:
Allow the muffler to cool.
Remove the two (2) deflector screws (A).
Remove the deflector (B) and spark arrester (C).
Clean and inspect the spark arrester screen (A).
94
95
96
97
98
MAINTENANCE

Table of Contents

Other manuals for Efco MT 7200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Efco MT 7200 and is the answer not in the manual?

Efco MT 7200 Specifications

General IconGeneral
BrandEfco
ModelMT 7200
CategoryChainsaw
LanguageEnglish

Related product manuals