5
ASSEMBLY
Install Wheel Rack (See Figure 1)
1.
Position the wheel rack (A) underneath the
housing (B)
2.
Using three flange bolt (C), marked with R1, and
three nuts (D) to tight the wheel rack with the
housing
Install the Wheels (See Figure 2)
1.
Put the wheel (A) onto the axle (B), Make sure the
wheel disc flat side face to machine.
2.
Insert the cotter pin (C), marked with R2, into the
hole to secure the wheel on the axle, open the
two pins.
Install the Stand (See Figure 3)
1.
Position the stand (A) underneath the engine
base
2.
Using four flange bolt (B) and nut (C), both
marked with R3, to tight the stand with the
engine base
Install the Handle (See Figure 4)
1.
Position the handle(A) to by aligning the handle holes
on the both sides of hopper (B)
2.
Using four flange bolts (C) and nuts (D), marked with
R4, to secure the handle on the hopper
Figure 1
Figure 2
Figure 3
Figure 4
To Next Page
Loading...