effenne Inova - Vacuum Packing in MAGIC VAC; Family Containers; Vacuum Packing in Glass Jars; Vacuum Packing with MAGIC VAC

6 Vacuum packing in MAGIC VAC
®
Family containers
Multipurpose containers ideal for storage of frequently
used products such as dry and fragile foods; powder
foodstuffs; fresh, pureed or strained fruit and vegetables.
Their transparency and design makes them attractive to
display on kitchen shelves while ensuring that their con-
tents are clearly visible.
- Fill the container leaving at least 3 cm of room between
the contents and upper rim and position the cap on the
container.
- Connect the container lid to the air inlet (4) of the appli-
ance (fig. N) by means of the connection hose (13).
- Lock the lid (2) by pushing the LOCK buttons (5); the
machine will carry out a vacuum packing cycle and
turn off automatically on its completion.
- Remove the hose from the container lid.
- Press the central button (14) to open the containers
(fig. N).
7 Vacuum packing in glass jars sealed with metal caps
(Leifheit type)
Use the large-sized cap attachment to pack foods in
large-mouthed glass jars with a metal cap. A small-sized
cap attachment is also available for narrow-mouthed jars
sealed with metal caps.
- Fill the container leaving at least 3 cm of room between
the contents and upper rim.
- Connect the cap attachment (15) to the air inlet (4) of
the appliance by means of the connection hose (13).
Place the cap attachment directly on the jar with the
metal cap only (16) and press down, making sure it fits
correctly. (fig. O)
- Lock the lid (2) by pushing the LOCK buttons (5); the
machine will carry out a vacuum packing cycle and
turn off automatically on its completion. Make sure
that the cap attachment holds firmly by keeping it
pressed with your hand.
- Disconnect the hose from the cap attachment. Remove
the cap attachment from the jar.
- Apply the ring (17) supplied with the jar and screw it
down all the way (fig. O).
- To open a glass jar vacuum-sealed with a metal cap,
use the cap opener provided (the side with writing
should be turned up). Position the cap opener as
shown in figure P and gently pry open the cap until the
vacuum is released. Remove the metal cap. This
accessory allows you to reuse the cap.
8 Vacuum packing with MAGIC VAC
®
bottle caps
The MAGIC VAC
®
Bottle Cap may be used to seal partly
filled bottles of wine or non-fizzy beverages. Using the
Bottle Cap will allow you to create a vacuum inside the
bottle so as to slow down oxidisation and preserve the
freshness and flavour of its contents for a longer time.
17
OPERATING INSTRUCTIONS
- By means of the connection hose (13) connect the air
inlet (4) of the appliance to the MAGIC VAC
®
Bottle Cap
(18) (fig. Q). Press the Cap firmly into the bottle.
- Lock the lid (2) by pushing the LOCK buttons (5); the
machine will carry out a vacuum packing cycle and
turn off automatically on its completion.
- Disconnect the hose from both the Bottle Cap and the
appliance immediately.
- To open a bottle sealed with the MAGIC VAC
®
Bottle
Cap, simply pull the cap out of the bottle. You will hear
the air rushing into the bottle.
9 Vacuum packing with the cap attachment in MAGIC
VAC
®
Executive containers or in containers sealed with
MAGIC VAC
®
Universal Caps with the previous model of
knob
To use the Cap Attachment in MAGIC VAC
®
Executive con-
tainers or in containers sealed with MAGIC VAC
®
Universal
Caps with the previous model of knob, read the instruc-
tions supplied in our web page www.flaemnuova.it
Warning: Do not store the machine with the LOCK buttons engaged