Effer DMU 3000 PLUS

To Next Page

To Previous Page

Electronic device DMU2000 - DMU3000 - DMU3000 PLUS

THE POWER OF PERFORMANCE

14 2nd boom safe opening device (ON=2; OFF=100)

You can operate an automatic device which stops the crane opening manoeuvre when the crane is

folded behind cab - if the second boom cylinder, on the rod side, has not sucient pressure inside to

prevent the second boom from falling down as soon as it releases from the support tted to the col-

umn.

The crane shall be delivered with the device o (the number 100 appears on the box).

15 Enabling angular sensor to detect 1st boom position

As the anti-bridge function is installed, an angle sensor is tted to the rst boom, and the function must

be enabled otherwise the DMU reports an error.

Enable is on when the box is selected (tick).

NOTE: the DMU emits an output electric signal, according to the position of the crane boom. This

signal controls the operation of an alarm, or better, prevents crane stabilizers from rising , when crane

boom is in wrong position.

The authorization above is only possible on cranes where the DMU 2000 or DMU 3000 are ﬁtted . On

cranes where the DMU 3000 PLUS is ﬁtted, OFF appears next to this indication and you cannot use

this function.

Effer DMU 3000 PLUS - Page 17