EasyManua.ls Logo

EFLOW E3 NITRO - BMS Idle Power Warning

EFLOW E3 NITRO
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
the BMS uses a small amount of electric energy to run
the microprocessor ALL OF THE TIME, even when the
bicycle is not in use. In other words, the BMS is always
on, consuming a small amount of power from the battery.
This power drain is inconsequential under normal use, as
the battery is recharged on a regular basis. However, if
the electric bicycle is not used for an extended period
of time, this constant power usage will eventually
completely drain the battery, resulting in permanent
damage. Therefore, it is VERY IMPORTANT that you
recharge the battery AT LEAST every 30 days if the bicycle
is not in use. Failure to follow this battery maintenance
procedure will void the warranty. If you have any
questions regarding this instruction, please do not hesitate
to contact the Currie Tech Customer Service Department
at 1-800-377-4532.
If you have any questions about this battery or its usage, please
do not hesitate to contact the Customer Service Department at
Currie Tech at (800) 377-4532.
Battery Disposal
We are condent that you will enjoy many miles of pleasurable
riding with your eFlow bicycle battery. However, batteries
do eventually wear out. When this happens, we urge you to
properly dispose of your used battery.
For guidance regarding proper disposal of your battery,
please contact the Customer Service Department at Currie
Tech. Or, you can nd very useful information regarding used
battery drop-off sites from the Rechargeable Battery Recycling
Corporation (RBRC) at www.rbrc.org.
Currie Tech Technical and Customer Service: +1 800-377-4532
p. 44/52