Need help?Do you have a question about the EFLOW E3 NITRO and is the answer not in the manual?
Importance of wearing a quality bicycle helmet for reducing injury severity.
Bicycle designed for single rider; rack is for luggage or battery, not second rider.
Definition of 'Warning' indicating a potentially hazardous situation leading to injury or death.
Definition of 'Caution' indicating a potentially hazardous situation leading to equipment damage or failure.
Maximum speed, range, and weight capacity of the eFlow bicycle.
Type and power rating of the electric motor used in the eFlow bicycle.
Details on the standard battery pack's model, chemistry, voltage, capacity, and weight.
Specifications for the eFlow bicycle charger, including model, dimensions, input/output voltage, and amperage.
Warning against disassembling or adjusting key components to avoid damage and voiding warranty.
Warning about improper adjustment of the front wheel quick release leading to separation and accidents.
Warning that full cam force is needed; holding the nut like a wing nut is unsafe.
Step-by-step guide for installing the front wheel quick release, including diagrams.
Warning about insufficient clamping force and how to re-adjust the quick release.
Warning about improperly secured seat post leading to loss of control and accidents.
Checking brakes before each ride and understanding their function.
Warning that damaged or misadjusted brakes degrade stopping capabilities, risking accidents.
Warning that brakes lose effectiveness when wet; advice for riding in wet conditions.
Instruction to use ONLY the battery supplied with the eFlow bicycle.
Caution against using unauthorized batteries, which voids warranty and can cause damage.
Step-by-step instructions for installing the eFlow electric bicycle battery into the seat post 'shoe'.
Step-by-step instructions for removing the eFlow electric bicycle battery.
Explanation of the pedal torque sensor and recommended procedure for turning the bike on and starting to ride.
Explanation of the two operating modes: Power-On-Demand (POD) and Pedal Assist (PAS).
Step-by-step instructions for mounting and connecting the eFlow display to the handlebar mount.
Procedure for entering setup mode and setting the clock and speed units on the display.
How to switch between Pedal Assist (PAS) and Power-On-Demand (POD) modes using the '+' button.
Meaning of 'Error 13: Comm Error' and troubleshooting steps like checking connections.
Warning against pedaling backward while shifting to prevent derailment and loss of control.
Recommendation to pedal if speed drops below 7 mph in POD mode to prevent damage to motor, controller, and battery.
Warning about improper battery use, charge, storage voiding warranty and causing hazardous situations.
Warning that short-circuiting battery terminals can cause fire, injury, or death.
Instructions for charging the eFlow battery, either installed or removed from the bike.
Warning to use only the supplied charger to avoid warranty void, battery damage, or fire.
Procedure to locate and use the charger port on the bicycle frame.
Steps for connecting the charger to the battery receptacle on the bike.
Procedure for charging the battery when removed from the bicycle.
Steps for connecting the battery adapter and plugging it into the battery pack.
Warning that improper charger use can cause fire, property damage, and injury or death.
Caution about the BMS using small power even when idle, potentially draining the battery.
Warning about BMS power drain during extended non-use, leading to permanent battery damage if not recharged.
Troubleshooting steps for when the bicycle fails to power on, checking battery and installation.
Troubleshooting step: Recharge the battery as per Section VIII or manual.
Troubleshooting step: Ensure the battery is securely plugged into the receptacle (refer to page 23).
Troubleshooting steps for when the bicycle turns on but the motor does not operate.
To Next Page
General